Output DC 12V Ozone Residential Magnetic Water Filters for Soft
ECO Laundry Generation II is an environmentally friendly appliance
intended for using in a residential laundry facility.
ECO Laundry Generation II is designed to work with your washing
machine, adopts magnetizing principle to treat the tap water
firstly, then mixed active oxygen and silver ions into the
magnetized water used for laundry.The processed water can wash
clothes cleanly and kill bacteria on clothes without leaving any
ECO Laundry Generation IIhas the main functions as below:
Soft the water
Sterilization and disinfection;
Decontamination and purification;
Energy conservation and environmental protection
The operation of ECO Laundry Generation II is easy and convenient.
As long as you install ECO Laundry Generation II properly, you
simply need to operate your washing machine following
manufacturer’s operation instructions. ECO Laundry Generation II
will start working automatically when the washing machine starts to
work, and it will automatically turn off when the washing machine
TECHNICAL SPECIFICATION TABLE
ECO Laundry Generation II(OLK-W-02)
|Input: AC 100-240V/50-60Hz|
Output: DC 12V 3A 36W
0.4 ~ 0.6 mg /L
Minimum:15 psi Maximum:75psi
USE & SAFETY CONSIDERATION
Before using, please read the User’s Manual carefully.
Disconnect ALL power before servicing.
Do not operate the unit with the cover removed.
Maximum water inlet pressure is 75psi.
Use the supplied new hose when connect the ECO Laundry Generation
II unit to your washing machine. You should replace any existing
washing machine hose that is more than 2 years old, with a new one.
To prevent leakage caused by back-flow from the washing machine, do
not leave your water hose disconnected. Simply turn the water off
at the valve / faucet on the wall, leaving the hose connected.
Use a soft cloth dampened with water. Do not clean your ECO Laundry
Generation II with harsh chemicals, abrasives or cleansers.
Do not mount the ECO Laundry Generation II unit vertically or at an
ECO Laundry Generation II is designed for residential use only and
is not intended for use in a commercial or industrial setting.
ECO Laundry Generation II can work normally in the temperature
category 0℃~78℃, without components breakdown.
Silver Ion Probe
ECO Laundry-P- SI
ECO Laundry-P- PCB
ECO Laundry-P- PCO
ECO Laundry-P- OM
ECO Laundry GenerationII requires 120Volt 60Hz power on a 15amp
fuse or Circuit Breaker.
A dedicated electrical circuit, equipped with an approved GFCI
outlet, is recommended for supplying power to your ECO Laundry
NEVER use an extension cord or a power adapter other than the one
provided with ECO Laundry Generation II.
Water pressure of 10 to 75psi is required to correctly operate your
ECO Laundry Generation II.
To avoid the possibility of water damage (i.e. a hose leak) it is
recommended that you always turn off the water supply
valves/faucets when the washing machine is not in use.
Water quality may affect the performance of your ECO Laundry
Generation II. If you have water quality concerns, such as high
content, consult a water filtration expert.
ECO Laundry Generation II will offer a metallic plate, a power
adapter, 4-1/4 tapping screws, a hose, a wrench, and a screwdriver
1. The ECO Laundry Generation II should be fastened to the wall,
just above and behind your washing machine. First, fix the metallic
plate on the wall. The metallic plate has three mounting holes,
together with 3 anchor screws. Fasten the metallic plate on the
wall with the anchor screws to support the product.
2. Before installation, do not open the unit. There are 3 sockets
on the bottom of the unit.Collimate the 3 sockets in the holes of
the metallic plate, pull downward slowly, and then the unit is
hanging over the metallic plate.
3. Ensure that metallic plate is horizontal. Tilt installation may
affect the product operation and visualization.
4. Connect the water inlet on the ECO Laundry Generation II to the
cold water supply faucet; and connect the water to you washing
machine with the supplied hose. Make sure rubber washers are
properly installed in both ends of the hose before connection.
Properly tighten the hose to the inlet fitting, but do not over
5. Plug the supplied power adaptor into the DC adaptor plug-in on
the side of the ECO Laundry Generation II unit and then plug the
adapter into the wall outlet. Disconnect the power adapter when not
use the unit.
System Set Up
1. Turn on the water valve/faucet. Check the connections to ensure
that there is no leakage or dripping. Tighten the hose connections,
if necessary, but DO NOT over tight.
2. Connect power adapter, and then start your washer. Once the
water begins to flow, the blue light of the ECO Laundry Generation
II should begin to glow and your washing machine will begin to run
through the normal cycles.
INDICATORS AND ALARM SYSTEM
The Indicator light, viewed through the window in the front of the
ECO Laundry Generation II has three states.
A blue light indicates the normal operating condition of ECO
Laundry Generation II.
A flashing red light indicates the fan or ozone generator is not
A steady red light indicates that the Silver Ion Probe is not
working or has been consumed, as a product of normal usage. The
consumed Silver Ion Probe should be replaced with a new one. Please
contact with our Customer Service team for the replacement.
Your ECO Laundry Generation II is equipped with an internal leak
detector. If a leak happens to develop on the inside of the unit,
the water will accumulate on the bottom panel. The sensor will set
off an audible alarm and will automatically turn the unit off. This
alarm will continue to buzz until the leak is stopped and/or the
unit is unplugged. If this alarm should occur, you should unplug
the unit, turn off the cold water valve and call our Customer
Service team for support.
DAILY USE OF ECO LAUNDRY GENERATION II
The use of ECO Laundry Generation II is very easy after installed
and connected properly. You just need to operate your washer
according to the instruction provided by the manufacturer of your
Non-use or Vacation Care
Operate your washer and ECO Laundry Generation II only when you are
at home. If you are on vacation or won’t be using your washer for
an extended period of time, you should unplug the power supplies to
both the washer and ECO Laundry Generation II and turn off the
water supply. This helps avoid accidental flooding due to a water
pressure surge while you are away.
For some serious or special stains, we suggest that you pre-treat
them, just as you did before. For normally soiled laundry, you may
not need to use any detergent powder or other detergent.
Replacement of Silver Probe
Under normal residential usage, the Silver Ion Probe installed in
your ECO Laundry Generation II has a life expectancy of
approximately one and a half years.
When the indicator light (seen through the window in the front of
the unit) turns red, it shows that the Silver Ion Probe needs to be
replaced. Please contact our Customer Service team to order a new
Silver Ion Probe and replace it as the following step:
1. Turn off the water supply valve / faucet.
2. Turn on the wash machine momentarily to relieve any internal
water pressure within the ECO Laundry Generation II unit.
3. Turn off the washing machine and unplug the power adapter of the
ECO Laundry Generation II.
4. Push the ECO Laundry Generation II a little higher than the
metallic plate, and take it off from the metallic plate.
5. Find the 4 screws holes on the base, unscrew and press the
cover, you will see the Silver Ion Probe ( see the structure
6. Unscrew the Silver Ion Probe with the supplied wrench, and then
fix the new one. (Tighten the Silver Ion Probe in order to avoid
7. Reconnect the electrical connectors of the new Silver Ion Probe,
making sure that the retainer features snap together properly.
FREQUENTLY ASKED QUESTIONS
Do tough stains have to be pretreated?
We recommend that you continue to treat stains in the same manner
as always. Tough stains should be pre-treated in the same method as
before using the ECO Laundry Generation II. For normally soiled
laundry, the use of the ECO Laundry Generation II will allow you to
use less detergent or no detergent at all.
Does ECO Laundry Generation II work with all forms of water?
ECO Laundry Generation II will work with all household water
qualities, but the better the incoming water quality the better the
results you will have. If you use hard water, we recommend that you
use a water softener for hard water and/ or a pre-filter for
What types of washing machines can work with ECO Laundry Generation
ECO Laundry Generation II can be used with all almost any
residential machine. There are however two separate models. The
High-flow ECO Laundry Generation II is designed for most top load
washers that have no restriction in their water intake. The
Low-Flow ECO Laundry Generation II is designed for front load
washing machines or those that have a restriction in their cold
water intake. (High Efficiency Washer)
Will the ECO Laundry Generation II work with Commercial Washing
ECO Laundry Generation II is designed and recommended for
residential use only, not for any commercial or industrial
Is ECO Laundry Generation II only used with washing machine?
Yes, the treated water by ECO Laundry Generation II is only used to
launder clothes. The water from your ECO Laundry Generation II is
not intended for drinking or ingesting.
What parts will need to be replaced on ECO Laundry Generation II?
Silver Ion Probes will need to be replaced when consumed during
normal operation and usage. In the average application, under
normal usage, the Silver Ion Probe has an expected life expectancy
of up to one and a half years. When the indicator light turns red,
the Silver Ion Probe should be replaced. Please contact with our
Customer Service team to order a new Silver Ion Probe.
Your ECO Laundry Generation II is warranted to be free from all
defects in material and workmanship in normal household use for a
period of (1) year from date of purchase.
The warranty is granted only to the original purchaser and members
of his or her immediate household. The warranty is subject to the
following provisions. Any damages or malfunctions caused by
negligence, abuse, or use not in accordance with the Owner’s Manual
are not covered by this warranty. Likewise, any defects or damages
caused by unauthorized service or the use of other than Genuine
Wowtech parts are not covered.
Wowtech will, at its option, repair or replace a defective ECO
Laundry Generation II or part(s) for the ECO Laundry Generation II
that is covered by this warranty. As a matter of warranty policy,
Wowtech will not refund the customer’s purchase price. Please
recorder the following Warranty Card when you purchase the unit
from Wowtech or the distributor.
To obtain warranty service you must return the defective ECO
Laundry Generation II or ECO Laundry Generation II parts along with
proof of purchase to Wowtech or Wowtech Authorized Warranty
Station. All transportation charges on parts, or units, submitted
under this Warranty shall be borne by purchaser. Unless this
Warranty is expressly renewed or extended by Wowtech, any repaired
or replaced part of unit shall be warranted to the original
purchaser only for the length of the unexpired portion of the
Please contact us without hesitation if you need help.